Next open the lid and insert a screwdriver into the lid switch actuator hole.
Whirlpool cabrio washer lid lock override.
Connect the blue and white wires start a load and wait until the lid lock red light comes on.
If it opens you re all set.
Let the washer sit unplugged for about 10 minutes then try lifting the lid.
This is one of the most common problems with direct drive washing machines.
Step 4 put the lid back down and plug the washing machine back into the electrical outlet.
This switch is connected to a solenoid that completes a circuit allowing the machine to run only if the top is.
You will need to take a look at the lid lock assembly and see if there is a visible issue with it possible electrical issue or possibly something else may be causing the issue.
At that point the lid light makes a clicking noise.
Ask your own appliance question.
There should be an object on the edge of the lid and a hole on the edge of the opening.
Whirlpool cabrio lid lock step by step instructions on how to replace a lid latch assembly w10404050 for washer you can not bypass these locks and.
Then connect the red wire to the blue and white wires and wash cycle should begin.
Place a magnet between the two so there is a magnetic connection between the lid lock and the solenoid inside the washer.
If you leave the lid.
Look for the lid lock switch on the underside of the top panel and where it fits into the appliance.
Then connect the lid lock open wire to the off pole of the switch and the lid lock closed wire to the on pole of the switch.
Under operation start with the new switch in the off position then start the machine wash cycle as you would normally do wait a couple of seconds and then hit new switch so that it is in the on position.
If the lid will not lock and keeps clicking on your whirlpool cabrio washer it is probably a faulty lock switch assembly.
If your whirlpool cabrio washer will fill with water but won t spin the lid lock switch is probably bad.
The lid lock mechanisms on some washers are heat activated which means overriding them is as simple as letting them cool off.
To diagnose this problem you ll want to put the washer in a spin mode.